Canoga-perkins 9145E Network Interface Device Software Version 2. Manuel d'utilisateur Page 62
- Page / 112
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
9145E NID Software User’s Manual Port Information
Port Configuration
54
Figure 5-10 Port Filters Screen
1. PVST + BPDU Filter - When enabled, the 9145E will discard PVST + BPDU frames received on
the specified port. Use the Space Bar to select User Port Enabled, Net Port Enabled, Both Ports
Enabled, or Disabled.
2. User Port Manager MAC Filter - When enabled, the 9145E will block packets entering the unit
which have the unit’s MAC address as the source MAC Address. This prevents spoofing of
Management frames. Use the Space Bar to cycle between User Port Enabled and Disabled.
3. User Port Test Network Filter - When enabled, the 9145E will inspect and discard all packets
entering its User port that have a source IP address on the same subnet mask as the Test
network. This prevents spoofing of test packets. Use the Space Bar to cycle between User Port
Enabled and Disabled.
4. 802.3ah OAM PDU Filter - When enabled, the 9145E will block 802.3ah OAM PDU frames from
being generated from or passed through the unit. Use the Space Bar to cycle between Enabled
and Disabled.
5. UDLD Filter - When enabled, the 9145E will block Cisco Systems proprietary tagged and
untagged UDLD frames from passing through the unit. Use the Space Bar to cycle between
Enabled and Disabled.
6. Management VLAN Filter - When enabled, the 9145E will block traffic that is tagged with the
Management VLAN on the specified port. This will not affect management packets that are
addressed to the 9145E. Use the Space Bar to cycle between Disabled, User Port Enabled, Net
Port Enabled and Both Ports Enabled.
Canoga Perkins Corp. Ethernet Network Interface Device 04-SEP-2008
Model 9145E-101-2-0 V02.10 F121 02:59:35
----------------------------------PORT FILTERS----------------------------------
1) PVST+ BPDU Filter Disabled
2) User Port Manager MAC Filter Disabled
3) User Port Test Network Filter Disabled
4) 802.3ah OAM PDU Filter Disabled
5) UDLD Filter Disabled
6) Management VLAN Filter Disabled
Select [1-6]:
------------------------------------Messages------------------------------------
- Software Version 2.1 1
- User’s Manual 1
- Table of Contents 3
- About this Manual 7
- How this Manual is Organized 7
- What is New in This Document 7
- Optional Applications 8
- Contacting Technical Support 8
- Document Feedback 8
- Chapter 1 9
- Introduction 9
- 1.3 Three Levels of Security 10
- Chapter 2 11
- Getting Started 11
- 2.1.1 About MIBs 12
- 2.1.2 9145E Set-up 12
- 2.3 Login 14
- 2.4 Main Menu 15
- 2.5 Supported MIBs 16
- Chapter 3 17
- System Configuration 17
- 3.1.3 Host Table 21
- 3.1.4 Trap Table 23
- 3.2 Trap Configuration 27
- Trap Configuration 29
- 3.3 Security Configuration 30
- 3.4 Account Configuration 32
- 3.4.2 Add or Edit an Account 33
- NOTE: SNMP only cannot FTP 34
- 3.5 System Information 35
- 3.9 Hardware Information 41
- Chapter 4 43
- Diagnostics 43
- 4.1 Loopback Setup 44
- 4.2 Latency/Jitter Test 44
- 4.3 PING Generation 47
- 4.4 VLAN Loopback 48
- Figure 4-6 VLAN Loopback 49
- 4.4.2 L2 Ping Generator 51
- 4.5 Cable Diagnostics 52
- Chapter 5 53
- Port Information 53
- 5.1 Link Status 54
- 5.2 Port Configuration 54
- 5.2.1 Hardware Information 55
- 5.2.3 VLAN Configuration 58
- 5.2.4 Port Filters 61
- 5.3 Layer 2 Statistics 64
- Layer 2 Statistics 65
- 5.4 RMON Group 1 Statistics 67
- 61/(62 Blank) 69
- Chapter 6 71
- System Alarms & Logs 71
- 6.1 System Log 72
- 65/(66 Blank) 73
- Chapter 7 75
- Utilities 75
- 7.3 Change Password 76
- 7.4 VT100 Baud Rate 76
- 7.5 PING Generation 76
- 7.6 Static ARP Table 77
- 7.7 Dynamic ARP Table 78
- 7.8 License Manager 78
- 71/(72 Blank) 79
- Chapter 8 81
- Software Upgrade 81
- 77/(78 Blank) 85
- Chapter 9 87
- 802.3AH OAM 87
- 9.1 OAM Control 88
- 9.2 OAM Peer Information 90
- 9.3 OAM Statistics 91
- 9.4 OAM Event Configuration 92
- 9.5 OAM Event Log 92
- OAM Event Log 93
- 87/(88 Blank) 95
- Chapter 10 97
- Class of Service 97
- Configuration 97
- 10.1 CoS Support 98
- 10.2 Classifier Mapping 98
- 10.2.3.2 DSCP Mode 101
- Enter. The cursor 101
- 10.3 Queue Configuration 102
- 10.3.3 Scheduling Scheme 103
- 10.3.4 Weight Parameters 104
- 10.5 Queue Statistics 107
- Appendix A 109
- Acronyms 109
- CANOGA PERKINS CORPORATION 112
Produits connexes et manuels pour Matériel informatique Canoga-perkins 9145E Network Interface Device Software Version 2.
Matériel informatique Canoga-perkins 9145E Standard NID Software Version 1.0 Manuel d'utilisateur
(100 pages)
(100 pages)
Matériel informatique Canoga-perkins 9145E10G Network Interface Device Hardware Manuel d'utilisateur
(55 pages)
(55 pages)
Matériel informatique Canoga-perkins 9145E10G NID Software Version 1.0 Manuel d'utilisateur
(116 pages)
(116 pages)
Matériel informatique Canoga-perkins 9145EMP Network Interface Device Hardware Manuel d'utilisateur
(50 pages)
(50 pages)
Matériel informatique Canoga-perkins 9145EMP NID Software Version 3.1 Manuel d'utilisateur
(202 pages)
(202 pages)
Matériel informatique Canoga-perkins 9145EMP NID Software Version 4.0 Manuel d'utilisateur
(229 pages)
(229 pages)
Matériel informatique Canoga-perkins 9145ELB NID Software Version 4.01 Manuel d'utilisateur
(152 pages)
(152 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.028 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels