Canoga-perkins 9145E Ethernet Network Interface Device Hardware Manuel d'utilisateur télécharger pdf (Page 37)

Installation 9145E Ethernet Network Interface Device User’s Manual

Connecting the Electrical Power

25/(26 Blank)

3.5.4 Connecting the Fiber Optic and UTP Ethernet Cables

3.5.4.1 Optical Fiber Cable Installation

NOTE: To avoid damaging the fiber end-surface or connector, use extreme

care when installing or removing cables.

Connect the Optical Fiber cables to the SFP modules as follows:

1. Plug in the optical cables with proper Tx to Rx or Rx to Tx orientation.

2. Ensure cable locks in place.

3. Label each cable with the signal direction (TX or RX).

3.5.4.2 UTP Cable Installation

Connect the UTP cables to the UTP connectors as follows:

1. Plug the UTP Cable into the RJ45 connector.

2. Be sure the locking tab is properly seated.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 53 54

Pas de commentaire

Canoga-perkins 9145E Ethernet Network Interface Device Hardware Manuel d'utilisateur Page 37