Canoga-perkins 9145E Ethernet Network Interface Device Hardware Manuel d'utilisateur télécharger pdf (Page 34)

9145E Ethernet Network Interface Device User’s Manual Installation

Installing the SFP Modules

3.4 Installing the SFP Modules

1. Determine which SFP Module(s) is/are required for the User, Network, and Multipurpose

ports by referencing the SFP Product Data Sheet.

2. Insert a module into each available port and push firmly to seat module (see Figure 3-10).

3. Raise latch to lock module in place.

Figure 3-10. SFP Modules

3.5 Connecting the Electrical Power

NOTE: When power is applied, all LED indicators will light amber.

3.5.1 AC Power

NOTE: Country specific power cords are available locally for installations

outside of North America

The 9145E uses a standard IEC320 AC Power Connector. Plug the AC power cord into the

socket at the rear of the 9145E and plug the other end of the AC power cord into a convenient AC

outlet.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Pas de commentaire

Canoga-perkins 9145E Ethernet Network Interface Device Hardware Manuel d'utilisateur Page 34