Canoga-perkins 9145E10G Network Interface Device Hardware Manuel d'utilisateur télécharger pdf (Page 34)

9145E10G Ethernet Network Interface Device User’s Manual Installation

Installing the SFP and XFP Modules

3.4 Installing the SFP and XFP Modules

1. Determine which SFP and XFP Module(s) is/are required for the User, Network, and Mul-

tipurpose ports by referencing the Product Data Sheet.

2. Insert a module into each available port and push firmly to seat module (see Figure 3-10).

3. Raise latch to lock module in place.

Figure 3-10. Install SFP and XFP Modules

3.5 Connecting the Electrical Power

NOTE: When power is applied, all LED indicators will light amber.

3.5.1 AC Power

NOTE: Country specific power cords are available locally for installations

outside of North America

The 9145E10G uses a standard IEC320 AC Power Connector. Plug the AC power cord into the

socket at the rear of the 9145E10G and plug the other end of the AC power cord into a conve-

nient AC outlet.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 54 55

Pas de commentaire

Canoga-perkins 9145E10G Network Interface Device Hardware Manuel d'utilisateur Page 34